Tube Clamp (x3)
| Part | Qty | |
|---|---|---|
| Tube clamp | 1 |  |
| M4 nut | 2 |  |
| M4x30 thumbscrew | 1 |  |
| M4x20 socket head screw | 1 |  |
1
2
- 1.Insert the two M4 nuts into the top pockets of the clamp.
- 2.Insert the M4 screw and thumbscrew through the side holes, then thread them into the nuts.
The Tubes Assembly
Tubes Assembly (x3)
| Part | Qty | |
|---|---|---|
| Tube clamp assembly | 1 | |
| Tube wide | 1 |  |
| Tube narrow | 1 |  |
| PTFE piece | 1 |  |
1
2
3
4
- 1.Slide a tube clamp onto the wider tube and tighten the M4 screw to hold it in place.
- 2.Cut a 3 cm by 1.5 cm piece from the PTFE sheet and stick it onto the outside edge of the narrow tube.
- 3.Insert the narrow tube from the back of the wider tube, with the PTFE piece on the side opposite the clamp, facing down.
- 4.Check that the narrow tube slides out until the PTFE piece reaches the clamp, then stops.
- 5.Tighten the clamp to keep the tube extended.
- 6.Repeat for the remaining tubes.